|MK III Modular Hand Guard
Length: Carbine (7.125" OAL)
Platform: Armalite AR-10,
pre-2010 Bushmaster, Rock
River LAR-8 or similar
Tube Style: Rapid Configuration
Machined from 6061 T6 aluminum with a 4140 steel barrel nut, this mid-length hand guard includes two JPHGS quick-detach sling studs.
Receiver Thread Pattern: 1 7/16" x 18 TPI
Inside Diameter: 1.75"
For the purposes of color matching your components, Flat Dark Earth and Olive Drab Cerakote correspond to the same colors in the Magpul pallet. Hand guards are run in Cerakote regularly on an as-ordered basis, which may add up to 2 weeks to delivery time.
Large-frame MK III Hand Guard models make use of an eccentric nut design whereby the barrel retainer nut is not centered in the receiver extension. This allows use of the same smaller 2" tube as our small-frame hand guard models rather than requiring a larger diameter. At the same time, this design does cause the barrel to sit slightly below center in the hand guard tube. This is purely an aesthetic characteristic and does not affect barrel-tube parallelism or durability.
Tactical Rail Selection
Any rail segments purchased at the same time as MK III Hand Guard are available at 20% off when selected from the the menus at right. All rails are anodized black regardless of any color option upgrade.
Full-length 12:00 rails or the 2-inch front sight rail (JPTR-FS) can be attached directly to the top of the hand guard tube while two- and four-inch accessory rails can be mounted directly (without backer plates) to the tube at the 6:00, 3:00, 9:00 and 45° positions using the 10-32 flathead screws included with the rail segments. Refer to the table below to determine which rails you need for a given application.
WARNING: The products offered for sale on this website can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov
© 2019 JP Enterprises. All rights reserved.