|Enhanced Cam Pin
Small Frame (.223)
Mil-spec never dies, but it's way past its prime.
When it comes to ARs, the smaller the part, the less people think about it. But that doesn't mean there's not room for improvement almost everywhere you look. Both in design and manufacturing, there are always gains to be made.
The JP Enhanced Cam Pin retains every critical Mil-spec dimension of the part but improves on both design and finish. A smoother operating system with lower overall wear in the components is the result.
In addition to receiving our low-friction QPQ finish, our Enhanced Cam Pins are also machined thicker than the usual undersized dimension of standard pins. An undersized pin drops right in but allows slop in the relationship between bolt, bolt carrier and cam pin. Looseness in these parts stresses the cam pin hole of the bolt during cycling, which is why bolt breakage is so common at this point. It also wears the cam pin faster as the carrier wears into the material at the bearing points. A tighter pin with low-friction coating cuts all this wear down dramatically.
Finally, we hold the upper receiver-to-cam pin width precisely to keep the bolt in alignment with the barrel. This reduces premature lug wear to the barrel extension.
These cam pins are available individually and are now the JP standard cam pin wherever we use them.
WARNING: The products offered for sale on this website can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov
© 2022 JP Enterprises. All rights reserved.