|JP Low Mass Operating System Carrier Group with JP EnhancedBolt
QPQ Black Finish
A low mass carrier provides the most significant improvement to felt recoil after the addition of a compensator. Our LMOS™ carriers remove much of the reciprocating mass out of the rifle's cycling. This translates into less felt recoil and less movement of the rifle. That means dramatically faster sight recovery and follow-up shots.
This carrier group includes our proprietary bolt design, the JP EnhancedBolt™. Superior in every way to standard bolts, it's manufactured from SAE 9310, providing drastically extended lifespan with design improvements that ensure superior function.
Our proprietary bolt design, the JP EnhancedBolt™ is superior in every way to a standard Mil-spec bolt. Manufactured from SAE 9310, it has a drastically extended lifespan while design improvements ensure superior function. This high pressure .308 model is designed to open up reliable function of AR platforms with over-pressured loads such as 6.5mm and 6mm calibers. This is achieved through use of a reduced diameter firing pin orifice that precisely accommodates the tip of the included low mass firing pin.
The EnhancedBolt™ is compatible with the JP LRP-07™ and the DPMS LR-308 platforms (or clones thereof) only and cannot be used to replace bolts in the Armalite AR-10 platform (or clones thereof).
The JP .308HP bolt does not allow for the use of excessive pressure, overloaded ammunition that exceeds SAAMI specifications. When evaluating new ammunition, always start on the low- to mid-range of any published load data and work up. A good indicator of working pressure is the primer retention on the subsequent loading of a case. A noticeable loss of primer pocket tension indicates that your ammunition has excessive pressure and has overworked the case.
This notice pertains to any rifle based on the large-format AR-10-type or LR-308 platform typically chambered in .308 Winchester, 7.62x51 NATO or other cartridges requiring the longer magazine format.
Be aware that these receiver platforms are not standardized like the AR-15/M16 platform for which most parts are cross-compatible. Before ordering accessories and parts for your large-format rifle, make sure the parts are compatible with your particular platform. This bolt carrier group is compatible only with the DPMS family of AR-10 products.
With the Armalite family of large-frame receivers, this carrier can only be used as a complete bolt carrier assembly group with a DPMS-pattern bolt such as our .308 JP EnhancedBolt. Interchanging individual components will result in an unsafe configuration. Do not under any circumstances mix and match components between the platforms.
Please select one of these options:
WARNING: The products offered for sale on this website can expose you to chemicals which are known to the State of California to cause cancer, birth defects or other reproductive harm. For more information, go to www.p65warnings.ca.gov
© 2021 JP Enterprises. All rights reserved.