|MicroFit™ Takedown Pin Set
Large Frame (.308)
Cure what ails your ill-fitting receiver set or just spruce them up with high-quality new look.
This set of pins includes both the front pivot pin and rear takedown pin for a large-frame receiver set. Select your pin size at right. Oversized pins will remove much if not all of the slack in a loose receiver set while undersized pins will help with easier takedown of overly tight receivers like those with excess finish buildup.
To gauge the pin fit for your third-party receivers, you can use standard takedown pins or gauge pins. For the AR-10, standard pins are roughly equivalent to a .278 gauge pin. Oversized and undersized MicroFit™ Pins are offset slightly over .001 larger or smaller.
Because test fitting of takedown pins is likely to produce wear marks, we cannot accept returns on MicroFit™ Takedown Pins.
|Made in the USA|
© 2017 JP Enterprises. All rights reserved.