Spending $140 or more for trigger parts on every AR-15 rifle you may own may not be realistic. If you can't quite pop for our complete trigger kit, or have too many rifles and can't justify expensive triggers in all of them, then this may be for you. You can achieve a significant improvement over stock parts by using a set of our custom trigger/hammer springs and the Rydol sear compound. With proper sear and hammer notch preparation, a livable 4.5 to 5.0 smooth trigger in a rifle with standard trigger components is possible. It will not have the extremely short engagement/over travel feel like the JP trigger, but you will have a smooth "roll-off" feel that will give usable trigger control. The spring kit includes trigger, hammer and disconnector spring and complete instructions on how to prep your parts for best results. Or, send in your lower assembly and we'll do it for you, complete with springs, professional work over of your parts, and return shipping included for $65.00.
Note: Use of this spring kit requires the use of US manufactured (domestic) ammunition or reloads with domestic (non-NATO spec) primers as ignition reliability will be reduced with hard low sensitivity primers as found in made foreign made ammunitions and NATO specification ammunition. Use these parts only in rifles for recreational or competition shooting. Do not use this spring kit for any defense or duty applications or any AR-10 type rifle. Order the JPFC-1T or JPFCP-1T for AR-10, duty or defense applications.
|JPS3.5||JP Reduced Power Spring Kit||$10.95|
|JPS3.5T||JP Reliability Enhanced Spring Kit||$10.95|
|JPS4.0||JP Duty Spring Kit, 4-4.5 Pound Trigger Pull with JP Fire Control Parts||$10.95|
|JPS4.5||JP CMP Service Rifle Spring Kit, 4.5-lb Trigger Pull with JP Fire Control Parts||$10.95|
|RYDOL3||Rydol Boron Nitride sear/hammer grease||$4.95|
|LPK-LTG||Lower parts kit for AR-15 excluding trigger, hammer and butt stock.||$38.95|
|JPFC-HS||JP Hammer Stop Block||$9.99|
© 2014 JP Enterprises. All rights reserved.